Meccano Strip Roller

Updated Summer 2025: This is a tool rather than a model, and is now working pretty well. I’ve had to bend quite a few strips and flexible plates, and I’d rather bend them smoothly if I can. They last longer and look better that way. So I bought a set of steel rollers that should enable me to build a rolling mill for strips, plates up to 2.5″, and even flat girders, I hope. Initially I couldn’t get enough power to the rollers, as whatever I fixed to the end of the driving roller to drive it just slipped. I ended up filing flats onto the end of the driving roller shaft, which did the trick. I’ve just used it for strips so far, including longer ones (which are a bit thicker than the shorter ones).

I’m not actually keen on filing flats onto rods, as they only seem to hold temporarily – the screws work loose after a short while. For that reason I’m not intending to file any flats on the rods on my loom, if I can possibly avoid it.

The roller was based on one built by Arup Dasgupta, which itself was based on earlier designs. Mine is more robust due to the doubled 5 1/2″ strips and doubling the pinions up. A tyre on the pulley doesn’t work: it will slide round.

Parts list: 8 x 2, 4 x 3, 1 x 4, 1 x 10, 12 x 12, 1 x 19b, 1 x 19h, 6 x 26, 4 x 48, 2 x 59, 1 x 63, 1 x 64, 1 x 80c, 1 x 173a, plus nuts and bolts and a set of 3″ rollers, which I sourced from John Thorpe.

The crank is made up from a long crank handle extended with a 3″ screwed rod by means of a coupling and an adaptor for screwed rod. The screwed rod runs through a threaded boss that’s hinged onto a 1 1/2″ double angle strip and a 1″ double angle strip (made up from a fishplate and 2 angle brackets).

A few photos: