September 2026

Introduction
There was a version of this model in the 1916 Meccano Instructions Book, and in 1928 an improved version was issued as a Super Model (number 7 in the series). It was included initially with Outfit 6 and subsequently with Outfit K.
This is a simple model, as Super Models go, and the build didn’t give any serious problems. The finished scales work OK, but they aren’t particularly accurate. I’m pretty sure that’s because the crucial knife-edge bearing is nowhere near sharp enough. It’s formed by balancing two centre forks on the teeth of a couple of pinions, and centre forks really aren’t sharp enough for the job. I could have experimented with something like a Stanley knife blade instead, but I decided to leave it as it was and move on.
Build issues
There weren’t very many of these:
- The scale on the original is just a long strip of unsupported card. I backed this card with a 9.5″ strip, with an angle bracket at each end.
- The 1934 version of the leaflet I was using (from Geoff Wright’s reprint book) illustrates the model using 5.5″ braced girders for the base, but some added text says use strip plates instead – the braced girders were no longer included in the new Outfit K. The parts list omits the braced girders, and includes 3 of part 195 instead. Post-war part 195 was a 7.5″ by 2.5″ strip plate, which makes no sense for this model. However, from 1934 to 1938 part 195 was a 5.5″ by 2.5″ strip plate, which is what was intended for this revised version of the model. I used braced girders – if you want to use 5.5″ by 2.5″ flexible plates (part 192) then you’ll probably need to add more rigidity to the framework.
- The parts list omits one of the three 5.5″ angle girders you need, three reversed angle brackets, and about 10″ of sprocket chain.
