Part 141 – Wire line (for suspending clock weights)

August 2026

I’ll post a photo here when I’ve made one!

I’ve never even seen one of these, but if I’m ever going to build Super Model 14a, the Grandfather Clock, I’m going to need one. It seems to be reasonably easy to make one though, and there is a blueprint available online. It’s one drawn by Niels Gottlob in the 1960s or 1970s, not a Meccano original blueprint, but as far as I know it’s all we’ve got.

The hook is a normal pre-war Meccano hook, and the rest is wire that’s easy enough to find online, so I’m not too worried about recreating one of these. I’ve got the hook and the wire already.

Part 217a – 1 1/4″ disc

Updated September 2026

In 1932 Meccano launched the X Series outfits, which were a budget solution to Trix undercutting the main Meccano range. They weren’t particularly successful, and were discontinued in 1936. There were, however a couple of parts in the X Series range that were absorbed into the main Meccano range in 1937, as they filled in obvious gaps. One was the 3/4″ disc, which was renamed the 3/4″ washer and became part 217b, later renumbered part 38d. The other was X Series part X475, the 1 1/4″ disc, which became part 217a. It was red-painted steel, with eight holes. It was still in the Meccano parts list in November 1941, but that was the last we heard of it.

So there were two of part 217a in the Meccano Outfits 3 and 4, and four in the bigger outfits, for just four years. After the war, part 24a appeared in 1950, which was made of brass from the start, now the size of a bush wheel, i.e. 1 3/8″, and renamed the wheel disc.

I want to have an Outfit 10 ‘superset’ so I can build any Outfit 10 model from any era, so I needed four of these. And now I’ve got them.