The Meccano Stiff-Leg Derrick

July 2026

Introduction

This is Super Model no. 6, and is one of many Meccano cranes. I have to confess I wasn’t really looking forward to building it: in the leaflet it looks very simple and not very impressive. Once built, however, it’s quite an elegant and impressive thing. It’s big, for one thing. What’s more, it works properly – I take my hat off to whoever designed this one.

A smaller version of this model was in the 1916 Meccano Instruction Book 1, and the Super Model version first appeared in 1925. The build instructions were issued in leaflet form from 1928.

The Build

This was reasonably straightforward for a change, and I enjoyed putting it together. Perhaps because it’s a skeletal model, the leaflet pictures show most of the detail you need and there’s relatively little guesswork needed.

As usual the leaflet parts list is incomplete and inaccurate: you need more cogs and sprockets, you need an extra 5 1/2″ strip and four 2 1/2″ angle girders. And the parts for the radius indicator aren’t included in the parts list. On the other hand you don’t need any 3 1/2″ angle girders – the six I had ready I used as a load for the crane instead.

I made one improvement to the gearbox. There are two levers (24 and 26 in Fig. 5) that move rods to change which crane function to engage (rods 16 and 25 in Fig. 5). There’s nothing to stop the levers moving with the vibrations of the motor, and engaging or disengaging cogs when you don’t want that to happen. This is a common problem with Meccano gearboxes, and I’ve fixed it in different ways. This time, it was easy to fix lever 26 by tightening up the bolt fastening it to the trunnion, giving it some friction. Lever 24 needed a bit more thinking about. What I ended up doing was moving lever 26 and the trunnion over by 1″, which made room to mount a short rack strip 1/2″ above and in front of the 5 1/2″ strip (parallel to it), using a couple of reversed angle brackets. The rack strip is there to stop the lever 24 from moving on its own, so I needed the lever to engage intermittently with the rack strip. I put a compression spring onto a centre fork, pushed it through the top hole of lever 24, and fixed a handrail coupling to the fork. This meant I could move the lever by pulling the handrail coupling and centre fork back against the spring, moving the lever sideways, then letting the spring push the centre fork back into a new position on the rack, holding the rod in its new position. A 1″ rod through the handrail coupling made it easier to hold. And I labelled up the three positions on the rack so I’d remember what was what.

Oh, and I used anchoring springs rather than spring clips to anchor the two cords in the gearbox.