Meccano Plate Roller

March 2026

I’d already built a strip roller, but the rollers on that are only 3″ long. To build the Super Model no. 15, the Baltic Tank Locomotive, I was going to need a roller capable of bending plates 3 1/2″ wide. To be honest I wasn’t sure whether that could be done with Meccano, as it needs a lot of pressure to bend those plates. I decided to have a go anyway, although I had a fallback plan to use flexible plates instead if I couldn’t bend the rigid plates.

The 6″ rollers once more came from John Thorpe, and the roller was based on the design of my strip roller. I made this one a bit stronger, replacing the transverse strips with angle girders.

The roller works pretty well, considering it’s such a simple construction. I needed to bend two sets of 5 1/2″ by 3 1/2″ plates for the loco model. The first set was for the cab roof, and needed a fairly gentle bend across the whole plate. By very gradually increasing the bend in repeated rolls, I got a very good curve on the plates, and the roller didn’t explode. The second set of plates was for the top of the coal bunker, which needed a tighter curve, only at the end of the plates. Getting this tight curve was too much for the rolling machine – I just couldn’t roll the plate through the machine. What I could do though was to bend the plate without rolling it, then move it on a bit, then bend a bit more. That worked well enough to get the bends I needed.

I’d just add that the rollers themselves didn’t bend at all under the pressure. It was just too much for my Meccano. Thanks John!

As for bending an 8″ axle rod into a semicircle, which the loco also needed, I did that using a Workmate, a length of pipe and a pipe wrench!