Part 155 – Rubber ring, 5/8″

In the 1929 No. 7 outfit there was a single squashy rubber ring included, with part number 155. It appears to have been intended solely for building the clutch mechanism for Super Model 1 – the New Meccano Motor Chassis. The 5/8″ is a bit misleading, as the external diameter was greater than this, but it’s not the same part as the thinner and harder 1″ ring introduced in 1937 for use as a tyre on a 1″ pulley. The latter part was initially numbered 155a, but was renumbered 155 later, once the original 155 had disappeared from the catalogues and outfits.

If you’re building the Super Models, you need to know that it’s this old part you should be using: 1 for either version of the Motor Chassis (1 and 1a), and 2 for the New Loom (16a). However, as far as I can see, it’s probably only the later version of the Motor Chassis (1a) that really needs it. In the earlier Motor Chassis, the ring is fitted over a 1″ pulley, so a later 155 ring would probably do the job (I haven’t built this clutch so can’t be absolutely sure). The later model uses the ring as a loose fit over a 1/2″ pulley, pushing it against a 7/8″ bevel gear for friction, so the later 155 ring won’t do the job – you’d have to do a bit of redesign. As far as the loom is concerned, the later part 155 works fine.

I thought I didn’t have any of these, but I just thought I’d check through a box of what I thought were non-Meccano bits that were in a box of assorted parts I bought alongside my No. 10 outfit. Lo and behold I appear to have one. It’s old and a bit perished, but it ought to survive being built into a Motor Chassis 1a clutch at some future date. The photo shows it next to a 1″ pulley for scale.