Updated May 2026

These were the very first Meccano tyres. Their first appearance looks to have been in a revised version of the Meccano Motor Chassis leaflet in 1921: the tyres in the illustrations look identical to part 142, but no such Meccano part had been announced at this point. These leaflets predate the main Super Model series, and the model is not the same as the later Super Model no. 1. The same 1921 chassis and tyres featured in Meccano Magazine, in the September and October 1923 issues, and again in the February 1924 issue, which featured a limousine body based on the same chassis. Two months later there was a tiny announcement printed in the April 1924 MM issue that finally mentioned that part 142 was available. They also appeared listed in the available parts in the 1924 Meccano manual.
These rings pre-date the better-known 3″ tyres by about four years. There were 4 in the largest 1926 outfit (No. 7), but in 1928 the Dunlop tyres effectively replaced them. Three rings were retained in the No.7 outfit and its successor L outfit though, so that you could build Super Model no.3: Motor-cycle and Sidecar. When the new No. 10 outfit appeared in 1937 they were gone, and they never reappeared after the war. I imagine they were retained purely because the new tyres were too bulky for the design of Super Model 3. The blueprint diagram shows they were 3 1/8″ external diameter, 2 1/2″ internal diameter, made of circular cross-section vulcanised rubber with a diameter of 5/16″. They were either white or off-white.
I wanted to build the motor-cycle model so I needed three of these rings. Originals are next to impossible to find, so I looked around to source something similar. Luckily there were Nitrile Rubber O-rings the same size available on Amazon, although they are black. They cost a bit as they are shipped from China, but they are the right size. The ones I’d recommend are 85mm x 69mm x 8mm. I bought one with 80mm external diameter first, but it was difficult to get onto a 3″ pulley. The 85mm rings are a good secure fit. Next I painted them with three coats of Humbrol matt cream acrylic paint. I went for cream rather than white as old rubber is not going to be white for long, and cream seemed more appropriate for a vintage look with red/green Meccano. They look good. Stretching them onto pulleys resulted in a little damage, but that touched up pretty well, and they aren’t coming off again as I’ve got plenty of pulleys.
I’m now planning to build the Meccano Limousine featured in MM in February 1924, so I’ve ordered a fourth O-ring. Watch this space – it’s probably going to be my project for Spring 2027.